1. Eliminating processing semi products, reducing the cost of raw materials
It’s reported, LFT-D molding technology in the production of large structure parts is 40% ~ 50% cheaper than GMT
materials pressing molding parts, and 30% ~ 40% cheaper than LFT-G pellet injection molded parts.
2. Shorter processing period, which improve the production efficiency
Traditional thermoplastic composite molding firstly process basic resin and glass fiber composite into sheet metal
pellets or semi-finished products, and LFT - D production line reduce the step of processing semi-finished production,
and the polymer only need one heating process, which reduce the effect of heating on the properties of the polymer.
3.Lower scrap rate
Recycle waste on line and reuse ;
4. 100% scrap recycling
LFT-D waste recovery system crushed the waste into pellets and be feed into the twin screw extruder by loss-in-weight feeder, maximum recycling waste can reach 15% of the output, and no any bad influence on the performance
of product. This is not only to achieve the waste recycling, but also to ensure 100% waste free green production;
5. More flexible product design
The type, length, content of the fiber, and the composition and formulation of the matrix resin can be adjusted
according to the technical requirements of the products;
6. Smaller equipment space
Save the middle production and transferring semi - finished equipment, greatly reducing the space of the production line.